Filter
Top Products
Chapter 4 Command-Line Reference 4-151
4.3.15.1 switchport priority default
Use this command to set a priority for incoming untagged frames, or the priority of
frames received by the device connected to the specified interface. Use the no form
to restore the default value.
Syntax
switchport priority default default-priority-id
no switchport priority default
default-priority-id – The priority number for untagged ingress traffic.
The priority is a number from 0 to 7. Seven is the highest priority.
Default Setting
The priority is not set, and the default value for untagged frames received on the
interface is zero.
Command Mode
Interface Configuration (Ethernet, Port Channel)
show interfaces
switchport
Displays the administrative and operational status of
an interface
PE 4-96
Layer 3 and 4 Priority Commands
map ip precedence Enables IP precedence class-of-service mapping GC 4-157
map ip precedence Maps IP precedence value to a class of service IC 4-158
map ip dscp Enables IP DSCP class-of-service mapping GC 4-159
map ip dscp Maps IP DSCP value to a class of service IC 4-160
show map ip
precedence
Shows the IP precedence map PE 4-161
show map ip dscp Shows the IP DSCP map PE 4-162
TABLE 4-20 Priority Commands (Continued)
Command Function Mode Page