Sunfire B1600 Switch User Manual


 
4-64 Sun Fire B1600 Blade System Chassis Switch Administration Guide June 2003
Default Setting
login local
Command Mode
Line Configuration
Command Usage
There are three authentication modes provided by the switch itself at login:
login selects authentication by a single global password as specified by the
password line configuration command. When using this method, the
management interface starts in Normal Exec (NE) mode.
login local selects authentication using the user name and password
specified by the username command (the default setting). When using this
method, the management interface starts in Normal Exec (NE) or Privileged
Exec (PE) mode, depending on the user’s privilege level (0 or 15 respectively).
no login selects no authentication. When using this method, the
management interface starts in Normal Exec (NE) mode.
This command controls login authentication through the switch itself. To
configure user names and passwords for remote authentication servers, you
must use the RADIUS or TACACS software installed on those servers.
Example
Related Commands
username (4-29)
password (4-64)
4.3.6.3 password
Use this command to specify the password for a line. Use the no form to remove the
password.
Console(config-line)#login local
Console(config-line)#