Filter
Top Products
Chapter 4 Command-Line Reference 4-59
Related Commands
snmp-server enable traps (4-59)
4.3.5.5 snmp-server enable traps
Use this command to enable the switch to send Simple Network Management
Protocol traps (SNMP notifications). Use the no form to disable SNMP notifications.
Syntax
snmp-server enable traps [authentication | link-up-down]
no snmp-server enable traps [authentication | link-up-down]
■ authentication – The keyword to issue authentication failure traps.
■ link-up-down – The keyword to issue link-up or link-down traps.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
■ If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to configure this
device to send SNMP notifications, you must enter at least one snmp-server
enable traps command. If you enter the command with no keywords, both
authentication and link-up-down notifications are enabled. If you enter the
command with a keyword, only the notification type related to that keyword is
enabled.
■ The snmp-server enable traps command is used in conjunction with the
snmp-server host command. Use the snmp-server host command to
specify which host or hosts receive SNMP notifications. In order to send
notifications, you must configure at least one snmp-server host command.