Sunfire B1600 Switch User Manual


 
4-98 Sun Fire B1600 Blade System Chassis Switch Administration Guide June 2003
Example
This example shows the configuration setting for Ethernet port NETP7.
4.3.9 Address Table Commands
These commands are used to configure the address table for filtering specified
addresses, displaying current entries, clearing the table, or setting the aging time.
Console#show interfaces switchport ethernet NETP7
Information of NETP7
Broadcast threshold: Enabled, 256 packets/second
Lacp status: Enabled
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Enabled
Allowed Vlan: 1(u),
Forbidden Vlan: 2,
Console#
TABLE 4-14 Address Table Commands
Command Function Mode Page
mac-address-table
static
Maps a static address to a port in a VLAN GC 4-99
clear mac-address-
table dynamic
Removes any learned entries from the forwarding
database
PE 4-100
show mac-address-
table
Displays entries in the bridge-forwarding database PE 4-100
mac-address-table
aging-time
Sets the aging time of the address table GC 4-101
show mac-address-
table aging-time
Shows the aging time for the address table PE 4-102