Filter
Top Products
B-8 Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003
This command for console
only.
Line mode (vty) can not use console parameter
commands.
This command is only valid
for adding a single port to a
an aggregated link.
Only one port can be added to an aggregated link
with this command.
This command is only valid
for the name of a single
port.
When setting the port description, multi-port
selection is not accepted.
This command is not supported
for management port in
current release.
The “no switchport allow vlan” command cannot be
used for the management port.
Trunk ID: trunk is out of
range.
Trunk id is not allowed.
Trunk trunk does not exist. This trunk does not exist.
Trunk trunk is a normal trunk. This trunk is a normal trunk.
Trunk with no members cannot
be displayed.
Trunk member cannot be configured or displayed.
Type "show ?" for a list of
subcommands.
You only input the “show” command.
Unknown error. Unknown error.
Unrecognized command. Unrecognized command.
1 Indicates the value specified for a command.
TABLE B-3
Command Line Error Messages (Continued)
Message Description