4-10 Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003
To enter the other modes, at the configuration prompt type one of the following
commands. Use the exit command to return to Configuration mode or the end
command to return to Privileged Exec mode.
For example, you can use the following commands to enter interface configuration
mode, and then return to Privileged Exec mode.
4.1.2.12 Command-Line Processing
Commands are not case sensitive. You can abbreviate commands and parameters as
long as they contain enough letters to differentiate them from any other currently
available commands or parameters. You can use the Tab key to complete partial
commands, or enter a partial command followed by the ? character to display a list
of possible matches. You can also use the following editing keystrokes for command-
line processing:
TABLE 4-2 Configuration Modes
Mode Command Prompt See Page
Interface interface {ethernet port | port-
channel id| vlan id}
Console(config-if)# 4-83
Line line {console | vty} Console(config-line)# 4-62
VLAN vlan database Console(config-vlan) 4-121
Console(config)#interface ethernet SNP5
.
.
Console(config-if)#exit
Console(config)
TABLE 4-3 CLI Editing Keystrokes
Keystrokes Function
Ctrl-A Shifts cursor to start of command line.
Ctrl-B Shifts cursor to the left one character.
Ctrl-E Shifts cursor to end of command line.
Ctrl-F Shifts cursor to the right one character.
Ctrl-P Shows the last command.
Ctrl-U Deletes the entire line.
Ctrl-W Deletes the last word typed.
Delete key or backspace key Erases a mistake when typing a command.