Filter
Top Products
B-6 Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003
B.5.2 System Errors
The key error messages generated by the switch are listed in the following table. To
control the message levels issued by the switch, see “logging history” on page 4-35.
B.5.3 Command Line Errors
The error messages generated by the switch for the command-line interface are listed
in the following table. Note that these messages are not written to the log file.
TABLE B-2 System Error Messages
Message Description Level
3
3 The syslog message level. (See “logging history” on page 4-35.)
module
1
create task fail.
1 Indicates the switch software module (for example, STA, VLAN, XFER, TRAP, or RMON).
Specified software module cannot create the task. 2
module task idle too long. Specified software module stayed in idle state too
long.
2
Allocate string
2
memory fail.
2 Indicates the value specified for a configuration setting.
Allocate memory failed for specified String.2
Free string memory fail. Free memory failed for specified String.2
string switch to default. Specified value is invalid or not supported; the default
value will be used. (Please refer to the on-line help or
this manual for information on acceptable values.)
3
TABLE B-3 Command Line Error Messages
Message Description
Ambiguous command: string
1
Ambiguous command.
Clear dynamic address error. Cannot clear dynamic address.
CLI internal error - contact
your local service provider.
CLI command internal error.
Copy error. Copy failed.
Exec-timeout could not be
disabled for vty session.
Telnet session cannot disable exec-timeout.
Factory default configuration
file cannot be deleted.
Factory default file cannot be deleted.
Factory default configuration
file cannot be replaced.
Factory configuration file cannot be replaced.
Failed to allocate resource. Not enough resources.