Filter
Top Products
DEFINING PRODUCTION JOBS DEFINING APPLICATIONS
Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 7-17
between -0.5” and +0.5” (-12.7mm and +12.7mm).
Offset buttons allow you to precisely position on the sheet where the
logical pages (data) will be printed. This is especially useful when
using pre-printed paper.
The left offset button is used to position the logical page on the left
side of the sheet.
The right offset button is used to position the logical page on the
right side of the sheet.
The Arrows increment the offset in the appropriate direction in units
of 0.1mm or 0.01 inch for each press.
The measurement units defined in the
Definitions>Application>Offset tab will determine the units
displayed here. The three decimal places is to allow a more
accurate conversion from mm to inches.
14. Press the IPDS Tab, if displayed, and continue. If the Line Mode tab
is displayed, go to step 17.
The IPDS screen is displayed.
Note: Line Mode will not be active, or displayed on the GUI, unless a
channel board is installed.
15. Choose the Jam Repositioning mode required.
Normal Jam Repositioning - All lost pages are automatically resent
and reprinted. This is the normal behavior (to automatically reprint
the jammed pages) and the DEFAULT value on the GUI.
Suppress MICR Jam Repositioning (not available for the 495).
Suppress all Jams Repositioning - No lost pages will be resent.
Any missing or damaged pages must be manually recovered.
16. Check the Eject to Front Facing Sheet Enabled box, if required
and choose the appropriate mode.