Filter
Top Products
PERFORMING ROUTINE MAINTENANCE CLEANING THE MACHINE
Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 8-27
Cleaning the machine
Three areas of the machine should be cleaned on a regular basis. These
are:
• The fuser glass (front and back).
• The Toner supply and collector areas.
• The touch screen.
The fuser glass (front and back)
The fuser glass should be cleaned periodically because poor fusing or
dirty background may occur if the glass is dirty. In addition toner particles
may adhere to the glass during printing. Check the fuser glass before
work and clean it if necessary. If a paper jam occurs, clean the glass
each time.
Handling notes:
• Be careful not to break the glass.
• The lamp goes out at power-off. Start cleaning after the lamp has
completely cooled down.
To clean the fuser glass:
1. Open the right and left printer doors.
2. Open the Fuser Door.
3. Extract the fuser A or B lamp unit.
4. Remove each lamp unit by pulling it towards you.
5. Check that the fuser glass and paper transport path are not dirty. If
Fuser A
Fuser B
Lamp Unit B Fuser Glass
Lamp Unit A
Fuser Glass