Filter
Top Products
ERROR CODES PROBLEM SOLVING
Page 9-24 Xerox 495 Continuous Feed Duplex Printer Operator Guide
16-11 Guide roller motor rotation alarm A rotation error has been detected in the guide roller motor.
1. Check that Roller Unit A[R1a] is correctly installed and the
thumbscrew is securely tightened (see "Replacing Roller unit
A[R1a]" on page 8-13).
2. Press RESET on the touch screen and then set the printer to
ready.
16-12 Fold-back motor rotation alarm A rotation error has been detected in the fold-back motor.
1. Check that Roller Unit B[R1b] is correctly installed and the
thumbscrew is securely tightened (see "Replacing Roller unit
B[R1b]" on page 8-15).
2. Press RESET on the touch screen and then set the printer to
ready.
16-13 Shield motor rotation alarm A rotation error has been detected in the shield motor.
1. Check the printing status and the paper position.
2. Press RESET on the touch screen and then set the printer to
ready.
16-16 Back tension motor rotation alarm A rotation error has been detected in the back tension motor.
1. Check the printing status and the paper position.
2. Press RESET on the touch screen and then set the printer to
ready.
19-4C Transfer guide 1 position error
(attach)
A position error has been detected in transfer guide A. It is not
attached.
1. Check the printing status and the paper position.
2. Press RESET on the touch screen and then set the printer to
ready.
19-4D Transfer guide 1 position error
(detach)
A position error has been detected in transfer guide A. It is not
detached.
1. Check the printing status and the paper position.
2. Press RESET on the touch screen and then set the printer to
ready.
19-7C Transfer guide 2 position error
(attach)
A position error has been detected in transfer guide B. It is not
attached.
1. Check the printing status and the paper position.
2. Press RESET on the touch screen and then set the printer to
ready.
19-7D Transfer guide 2 position error
(detach)
A position error has been detected in transfer guide B. It is not
detached.
1. Check the printing status and the paper position.
2. Press RESET on the touch screen and then set the printer to
ready.
1B-0B Paper width motor time-out 1. Press RESET on the touch screen.
2. Remove the paper jam (see "Clearing paper jams" on page 9-
3).
3. Restart the autoload procedure (see "Paper autoloading" on
page 5-4).
4. Press LOAD on the autoload panel.
Code Display Message Procedure