Filter
Top Products
ERROR CODES PROBLEM SOLVING
Page 9-20 Xerox 495 Continuous Feed Duplex Printer Operator Guide
08-05 Paper tension lever released (dur-
ing printing or emergency stop)
1. Open the right stacker door.
2. Set the paper tension lever to match the paper in use.
'Standard' is for ordinary printing. 'Weak' is for when printing
with special paper.
3. Close the right stacker door.
4. Press RESET on the touch screen.
5. Press FORWARD/REVERSE on the autoload panel to match
the correct perforation number.
6. Select FOLD-OUT/-IN on the autoload panel to match the
correct fold-out/-in position of the paper.
7. Press RESET on the touch screen and then set the printer to
ready.
08-10 Pinch roller unit open 1. Open the right stacker door.
2. Close the pinch roller unit.
3. Close the right stacker door.
4. Press RESET on the touch screen and then set the printer to
ready.
08-11 Pinch roller unit open (during print-
ing or emergency stop)
1. Open the right stacker door.
2. Close the pinch roller unit.
3. Close the right stacker door.
4. Press FORWARD/REVERSE on the autoload panel to match
the perforation number.
5. Select FOLD-OUT/-IN on the autoload panel to match the
correct fold-out/-in position.
6. Press RESET on the touch screen and then set the printer to
ready.
08-13 Tractor cover open 1. Close the tractor cover.
2. Set the paper ejection guide to the correct position.
3. Press RESET on the touch screen and then set the printer to
ready.
08-14 Tractor cover open (during printing
or emergency stop)
1. Close the tractor cover.
2. Set the paper ejection guide to the correct position.
3. Press RESET on the touch screen.
4. Press FORWARD/REVERSE on the autoload panel to match
the perforation number.
5. Press FOLD-OUT/-IN on the autoload panel to select the
correct fold.
6. Press RESET on the touch screen and then set the printer to
ready.
09-01 Stacker not ready The stacker table is not at the AUTO position.
1. Open the right stacker door.
2. Press AUTO on the stacker panel to raise the table to the
correct position.
3. Close the right stacker door.
4. Press RESET on the touch screen and then set the printer to
ready.
Code Display Message Procedure