Filter
Top Products
REPLACING THE DEVELOPER PERFORMING ROUTINE MAINTENANCE
Page 8-12 Xerox 495 Continuous Feed Duplex Printer Operator Guide
Replacing the developer
There is a counter linked to developer life. An Error Code 06-01 or 06-02
is automatically displayed when the counter reaches its theoretical
replacement value.
As a rule, you should only change the developer when the Error Code is
displayed. However, if a particular application requires better print
quality, you can change the developer before its normal end of life by
following the same procedure.
Note: Only use new developer. Re-using a developer that has already
been used can causes poor print quality and problems with the print
process settings.
CAUTION
Keep developer away from your eyes or mouth. If the developer gets on
your skin during replacement, immediately wash it off. Make sure that the
developer does not get in your eyes or mouth. If this occurs, consult a
doctor immediately.
Important Note: Replacing developer requires you to perform the
procedures in the correct order and to confirm that key steps have been
carried out. The instructions are provided at the touch screen where
confirmation is made.
To replace the developer, proceed as follows:
1. Press the button to switch to the consumables view which
shows the usage of all consumables.
2. Press the Change button beside Developer in the appropriate box,
Front or Back.
The developer replacement screen for the selected developer
change (front or back) will be displayed.
3. Follow the instructions on the touch screen.