Filter
Top Products
REPLACING THE TONER PERFORMING ROUTINE MAINTENANCE
Page 8-6 Xerox 495 Continuous Feed Duplex Printer Operator Guide
Replacing the toner
An error Code 04-01 or 04-02 is displayed and the patrol lamp flashes
green and yellow when a toner reservoir is low. The code is displayed for
both front and back toner reservoirs
Note: Do not add toner if the printer does not require it.
CAUTION
Keep toner away from your eyes or mouth. If the toner gets on your skin
during replacement, immediately wash it off. Prolonged inhalation of
excessive amounts of toner particles may cause lung damage. If this
occurs, consult a doctor immediately.
CAUTION
If you should get toner on your clothes, brush it off and wash the item in
cold water. DO NOT use hot water or dry cleaning as this may make the
mark permanent.
Note: Never re-use waste toner. Particles of paper are mixed in with it
and this could cause printing problems and result in premature wear.
Replacing Toner [Ka]
To replace the toner for the front marking unit, proceed as follows:
1. Press the button to switch to the consumables view which
shows the usage of all consumables and press the Change button
beside Toner [Ka] in the Front box.
The consumables replacement screen for Toner [Ka] will be
displayed.
2. Open the right and left printer doors.
3. Check that the Toner [Ka] LED is flashing.
4. Slide the toner cassette into the groove of the toner cassette
Toner Entry Port [Ka]
Toner Cassette Receptacle