DEFINING PRODUCTION JOBS DEFINING A PAPER PATH
Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 7-25
an existing Marks definition from the pull-down list.
A table showing details of the marks is shown on the screen.
• The X position is the distance from the edge of the paper
nearest the front of the machine.
• The Y position is the distance from the leading edge of the
paper.
• The W is the width of the mark measured from front to back of
the machine. The maximum value is 18 inches (457.2mm).
• The H is the height of the mark in the paper movement
direction. The maximum value is 18 inches (457.2 mm) or 14
inches (355.6 mm) if using the stacker.
• The columns identified by the side icons (front - and back-
marking units ) show the side for which the settings have
been made (see "Front and back marking units" on page 2-2).
Note: If you specify the marks definition outside the printable area,
you will fall into error. If you specify a value lower than 0.1mm, it
defaults to 0mm.
3. Press the button to enter details of a new mark;
or highlight an entry in the table and press the button to
modify an existing mark;
or highlight an entry in the table and press the button to
delete an existing mark.