Filter
Top Products
PAPER PATH SETTING THE PERFORATION POSITION
Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 5-9
Setting the perforation position
After a paper jam has been removed or if the paper position is changed
with the Forward or Reverse switch, you will need to set the perforation
position.
Note: This operation is not necessary at ordinary autoloading or during
automatic switching mode (e.g. changing from simplex to duplex). The
paper moves automatically to the correct position before starting to print.
To set the paper position:
1. Check the Perforation Number on the autoload panel.
2. Press Forward/Reverse on the autoload panel, to correct the paper
alignment.
3. Press the Fold-out/in switch so that the fold-out/in status of the
perforation at Perforation Number matches the Fold-out/in lamp
status.
Notes:
a. Even when the fold-out/in status of the perforation matches the
Fold-out/in lamp status in, press the Fold-out/in Select switch.
b. The Perforation Number changes with the paper length but is
not equal to the paper length value (inch). Be sure to check the
Perforation Number when setting the perforation position.
The Perforation Number may change with the printing mode
even when the paper length is the same.
c. If your paper is long and the perforation number becomes 13 or
more, be sure to use the supplementary table.
Tractor Cover
Scale
Perforation