Filter
Top Products
GETTING STARTED SWITCHING THE PRINTER ON AND OFF
Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 3-3
This procedure switches off the printer engine and the controller. To
switch off the engine only, press the Power button on the Production
screen.
Notes:
When turning the power off, check that the green lamp of the fuser is lit. It
takes up to four and a half minutes until the green lamp at the fuser
lights.
If the power is turned off immediately after printing, paper may be
scorched at the fuser. (Even after printing, the cooling fan will operate to
cool the fuser. Once the fuser temperature has reached a safe level, the
green lamp at the fuser lights.)
Do not attempt to power the printer off when the data lamp is green or
during economy mode switching. Doing so will result in errors when you
power the printer back on.
1. Ensure that all jobs are finished.
2. Press the STOP button on the touch screen to set the printer to Not
Ready.
3. Switch the Attachment offline by pressing the Online button.
4. Open the small door on the right panel to access the sub-operator
panel.
5. Press , the POWER OFF switch on the sub-control panel.
6. Switch off the mains power isolator (circuit breaker), if necessary.
7. Switch off any peripheral devices following the instructions in the
appropriate User Manual.
Remote powering on and off
Provision is made for a master device to remotely power on and off a
printer where the main power isolator is turned on. This is only possible
where the master device is physically connected to the printer through a
connector provided for the purpose, when the REMOTE/LOCAL switch
on the sub-operator panel is set to REMOTE and the master device
activates the correct signals.
Three signals are used:
• Power Pick will cause the printer to power up until a power ready
signal is received.
• Power Hold maintains power on until it is deactivated.
• Power Ready is generated by the printer to signal to the master
device that it is powered on.
Both Power Pick and Power Hold must be activated to power the printer
on.