Filter
Top Products
PROBLEM SOLVING ERROR CODES
Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 9-43
C0-0D CME time-out 1. Record the displayed error code and message.
2. Press the RESET button to clear the error code.
3. Set the printer to ready.
4. If the problem persists, power the printer off then on.
5. If the problem persists, call for service or advice quoting the
error code number and message.
C0-0E IOT read command time-out 1. Record the displayed error code and message.
2. Press the RESET button to clear the error code.
3. Set the printer to ready.
4. If the problem persists, power the printer off then on.
5. If the problem persists, call for service or advice quoting the
error code number and message.
C0-20 Hardware error (APEX chip) 1. Record the displayed error code and message.
2. Press the RESET button to clear the error code.
3. Set the printer to ready.
4. If the problem persists, power the printer off then on.
5. If the problem persists, call for service or advice quoting the
error code number and message.
C0-21 Hardware error (temperature sen-
sor chip)
1. Record the displayed error code and message.
2. Press the RESET button to clear the error code.
3. Set the printer to ready.
4. If the problem persists, power the printer off then on.
5. If the problem persists, call for service or advice quoting the
error code number and message.
C0-22 Hardware error (CAN bus#1) 1. Record the displayed error code and message.
2. Press the RESET button to clear the error code.
3. Set the printer to ready.
4. If the problem persists, power the printer off then on.
5. If the problem persists, call for service or advice quoting the
error code number and message.
C0-23 Hardware error (CAN bus#2) 1. Record the displayed error code and message.
2. Press the RESET button to clear the error code.
3. Set the printer to ready.
4. If the problem persists, power the printer off then on.
5. If the problem persists, call for service or advice quoting the
error code number and message.
C0-24 Hardware error (PCU board) 1. Record the displayed error code and message.
2. Press the RESET button to clear the error code.
3. Set the printer to ready.
4. If the problem persists, power the printer off then on.
5. If the problem persists, call for service or advice quoting the
error code number and message.
C0-25 Hardware error (ST10Fxxx chip) 1. Record the displayed error code and message.
2. Press the RESET button to clear the error code.
3. Set the printer to ready.
4. If the problem persists, power the printer off then on.
5. If the problem persists, call for service or advice quoting the
error code number and message.
Code Display Message Procedure