Filter
Top Products
PRODUCT OVERVIEW OPERATOR PANELS
Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 2-31
Forms Load Load
Feeds paper automatically to the
stacker table when pressed with
paper set on the tractor. This func-
tion is called autoload.
The main operator panel displays
“Autoloading” If paper is set up to the
stacker, the paper width is mea-
sured. Then the main operator panel
displays “Measuring paper width”.
Effective when the printer is not
operating. While the paper is auto-
matically being loaded, the LED of
this switch remains lit.
Cancel
Press this switch to stop autoloading
immediately.
Effective during autoloading.
Forms Length Sets the length of the form in inches.
The display will show the value
entered. Any changes made here
will change the perforation number.
Long
Increments the units by 1 for each
press of the button.
Short
Decrements the units by 1 for each
press of the button
One decimal
Increments the decimal position by
1/6 inch for each press of the button
Effective when the printer is not
operating and has no paper inside.
Perforation number Defines the position of the perfora-
tion on the tractor scale.
Effective during autoloading.
Forms Forward
Feeds paper 1/6” (4.2mm) toward
the stacker.
Holding down this switch feeds the
paper continuously.
Effective when the printer is not
operating
Reverse
Feeds paper 1/6” (4.2mm) toward
the hopper.
Note: For complete data fusing,
press this switch to align perforation.
Effective when the printer is not
operating
Note: If the forward / reverse button is pressed during a job (Data LED on),
the printer considers that the operator wants to realign the position of the
paper, and therefore discards data buffers and report a sense to the host.
The host will then re-send the pages.
Fold-out/in select Selects the swing guide direction.
This switch is used to select fold-out/
in at perforation before autoloading
and after a paper jam is removed
and the paper length is aligned with
the tractor scale.
The corresponding lamp will indicate
the setting.
Effective when the printer is not
operating
RSV Reserve switch
Name Function Effectiveness