Filter
Top Products
SWITCHING THE PRINTER ON AND OFF GETTING STARTED
Page 3-2 Xerox 495 Continuous Feed Duplex Printer Operator Guide
Switching the printer on and off
Power to the printer can be switched on at the sub-operator panel (Local)
or remotely (Remote) from an external device.
Local power on and off
To switch on the printer:
1. Check that the main power switch is set to ON. The main circuit
breaker is situated to the rear of the machine, close to the power
cable in the bottom left-hand corner.
2. Open the small door on the right panel to access the sub-operator
panel.
3. Make sure the REMOTE/LOCAL switch is set to LOCAL.
4. Press , the POWER ON switch on the sub-operator panel.
The touch screen goes through self tests before displaying the user
interface.
Note: This could take several minutes.
The printer warms up.
5. Switch on any pre- and post-processing devices following the
instructions in the appropriate User Manual.
To switch off the printer:
Counter
On
Off
Counter sw
Alarm
Power
Remote
Local