Filter
Top Products
DEFINING APPLICATIONS DEFINING PRODUCTION JOBS
Page 7-18 Xerox 495 Continuous Feed Duplex Printer Operator Guide
This allows you to request the position of the command sheet when
it reaches the stacker.
Normal Front - When a stack is removed from the stacker, the
command sheet is facing down. The stack must be turned 180
degrees for the command sheet to face up.
Reverse Back - When a stack is removed from the stacker, the
command sheet is facing up.
17. Press the Line Mode tab.
The Line Mode screen is displayed.
The controls available on this screen will vary according to the
emulation chosen.
Note: This is only available when a line mode emulation is selected.
18. Set the position of the Forms Overlay (3800-LIPS and 3800-SPOOL
only) using the Offset arrows to define the positioning of the overlay
on the page in the direction shown by the arrow.
The forms overlay is an electronic form into which the data is placed.
The settings can be entered in millimeters or inches by pressing the
corresponding buttons. The 0 button resets the margins to 0. The
settings made will be displayed in the Offset display to the right of
the arrows.
19. Choose the image rotation, 0°, 90°, 180° or 270°, required.
20. Choose the lines per inch FCB to use. The choices are 6, 8, 10 or 12
lines per inch.
21. Set the position of the Flash Overlay (Line Mode emulations only)
using the Offset arrows to define the positioning of the overlay on
the page in the direction shown by the arrow.
The flash overlay is a bitmap image that will be placed in the same