Filter
Top Products
115Digital Multi Effects (DME)
Chapter 1 MVS-8000 Functions
Detents
The system defines points called detents at regular intervals on the three-
dimensional space. Pressing the [CTR] button in the device control block sets
the current three-dimensional parameter values to the closest detent points.
(For details, see “Three-Dimensional Transformation Operations” in Chapter
11 (Volume 2).)
The following table shows the interval between successive detents for each
transformation operation mode (see page 116).
a) When a value is smaller than 1, 1/Aspect or 1/Perspective (z) is adjusted to an integral value.
Three-dimensional parameter default values
Each of the transformation operation modes has default values for three-
dimensional parameters. If required, you can return the current value to the
defaults by pressing the [CTR] button in the device control block twice in rapid
succession. (For details, see “Three-Dimensional Transformation
Operations” in Chapter 11 (Volume 2).)
The following table shows the default parameter values for each
transformation operation mode.
Skew –9.9999 to +9.9999
Operation mode Limits of three-dimensional transformation parameters
Operation mode Detent interval
Location XYZ 1.0000
Rotation, Spin 0.2500
Axis Location 1.0000
Location Size 0.2500
Aspect
1.0000
a)
Perspective (x, y)
Perspective (z)
1.0000
1.0000
a)
Skew 0.1000
Operation mode Default value
Location XYZ 0.0000
Rotation, Spin 0.0000
Axis Location 0.0000
Location Size 1.0000
Aspect 1.0000