Filter
Top Products
277Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
Device Control Block (Joystick)
The description below of frame memory
clip operations applies only to the MVS-
8000A/8000G.
All functions of the joystick type device
control block are equivalent to the functions
of the trackball type, except that the
trackball and Z-ring operations are carried
out with the joystick.
a Joystick
When the positioner operation mode is
enabled
By moving this, you can move the pattern
in the x-axis and y-axis directions.
When the three-dimensional transform
operation mode is enabled
By moving this, you can carry out
operations in the x-, y-, and z-axes.
When the following buttons are held down,
the joystick operation is switched to a finer
control. (fine mode)
• The button on the end of the joystick
• [SRC] button
• [TRGT] button
Depending on the settings made in the
Setup menu, the operation speed multiple
can be changed.
When the effect run control mode is
enabled
By moving the joystick sideways, you can
run the keyframe effect, independent of the
STOP NEXT KF, EFF LOOP, and similar
settings in the keyframe control block.
DEVUSER
M/E1
DME1
DME5
MENU
SHIFT
M/E2
DME2
DME6
ASP
PERS
SUB
AXIS
LOC
MAIN
LOCAL
K1
CB1
GLB
K2
CB2
CLR
WORK
BUFR
M/E3
DME3
DME7
X
P/P
DME4
DME8
Y Z CTR
RUN
CTRL
RSZR
CTRL
LOC
SIZE
ASP
LOC
XYZ
LOC
ROT
POS
RSZR
SRC
K3
TRGT
K4
Operating buttons
1 Joystick
MENU button
Region selection buttons