Filter
Top Products
411Key Setting Operations With the Key Control Block
Chapter 4 Keys
a) In the “4H mode” and when [Fine Key] (page 393) is on, the setting value range is 0 to 4.
To adjust the edge fill color
When [BDR] is selected, the [MORE] button lights amber. Pressing the
[MORE] button to turn it green then allows you to adjust the edge fill color
parameters with the knobs.
Setting the drop border or shadow parameters
When the [DROP BDR] or [SHDW] button is lit green, the parameter settings
differ between the “key drop OFF” and “key drop ON” modes (see page 54) as
shown below. Switching between these two modes is made by turning the
[KEY DROP] button on or off.
• “Key drop OFF” mode
a) In the “4H mode” and when [Fine Key] (page 393) is on, the setting value range is 0 to 4.
• “Key drop ON” mode
a) In the “4H mode” and when [Fine Key] (page 393) is on, the setting value range is 0 to 4.
Knob Parameter Adjustment Setting values
1 Top Top edge width
0 to 8
a)
2 Left Left edge width
0 to 8
a)
3 Right Right edge width
0 to 8
a)
4 Bottom Bottom edge width
0 to 8
a)
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0 to 100
2 Saturation Saturation 0 to 100
3 Hue Hue 359 to 0
4 Density Density 0 to 100
Knob Parameter Adjustment Setting values
1Width Width
0 to 8
a)
2 Position Position 359 to 180
4 Density Density 0 to 100
Knob Parameter Adjustment Setting values
1Width Width
0 to 8
a)
2 Position Position 359 to 0
4 Density Density 0 to 100