Filter
Top Products
415Key Setting Operations With the Key Control Block
Chapter 4 Keys
• When wipe is selected
• When utility 1 bus is selected
Applying a DME Effect to a Key
Note
For one M/E bank, DME effects (including DME wipes) can be used in up to
two places on the dedicated interface and in only one place on the SDI interface
simultaneously.
When combining the SDI interface with the dedicated interface, you can apply
DME effects to a maximum of three keys. (Requires a setting in setup.)
Assigning a DME to a key
1
In the key control block, press the delegation buttons [M/E1] and [KEY1].
2
Using the DME channel selection buttons, select the DME channel (DME1
to DME8) for applying the effect.
The lit colors of the [DME1] to [DME8] buttons indicate the DME
assignment.
Lit green: Shows the DME assigned to the currently selected key.
Lit amber: Shows the DME assigned to a key other than the currently
selected key.
Off: DME is not assigned.
To select a DME being used by another keyer
Press [Override], turning it on, then select the DME channel.
The later selection is valid, and the button lights green.
Using two or three DME channels on one keyer
When using the DME dedicated interface, proceed as follows.
Knob Parameter Adjustment Setting values
1 Size Pattern size 0 to 100
2 Soft Edge softness 0 to 100
Knob Parameter Adjustment Setting values
1 Clip Reference level for
creating mask signal
+109 to –7
2 Gain Gain –100 (shown as –00) to +100