Filter
Top Products
266
Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
b Bank selection buttons
BANK0 (bank 0): Assigns the memory
recall section to bank 0, of registers 1 to
10.
BANK1 (bank 1): Assigns the memory
recall section to bank 1, of registers 11
to 20.
BANK SEL (bank selection): After
pressing this button, press a button in
the memory recall section to select
banks 0 to 9.
c Memory recall section
This consists of 12 buttons with LCDs.
These display changes, according to
various operation modes.
d UNDO button
UNDO: After recalling a register, press this
button to return to the state before
recalling the register.
When contents have been saved to a
register, hold down the [STORE
STATS] button and press this button to
return the register to its state before the
save operation.
STORE STATS (store status): When a
save or delete operation has been
carried out on a register, this button
lights amber. After saving to a register,
hold down this button and press the
relevant register button to delete the
data in the register. Again, after a save
operation on a register, hold down this
button and press the [UNDO] button to
restore the register to its state before the
save operation.
e XPT HOLD (cross-point hold) status
display
A bus for which cross-point hold is set
appears as a green light.
f Numeric display
Depending on the operation mode, this
shows the pattern number of a wipe or
DME wipe, a bank number, a register
number, a transition rate, and so on in up to
four digits.