Filter
Top Products
199Setup
Chapter 1 MVS-8000 Functions
You can make the following settings.
Settings relating to overall switcher configuration (Config)
• System Phase: Adjust the switcher internal reference phase.
• Switch Timing: Specify the timing of video switching.
• M/E Config: Set the program configuration for the M/E and P/P outputs.
– Standard mode: Fix the maximum of four outputs (Out1 to 4) and
program output configuration as follows.
Out1: Program output
Out2: Preview output
Out3: Clean output
Out4: Key preview output
Program output: Clean output + key 1 + key 2 + key 3 + key 4
– Multi-program mode: Increase the number of M/E or P/P programs, and
assign any of the following to the maximum of six outputs (Out1 to 6). (M/
E Output Assign)
Program outputs 1 to 4, preview output, key preview outputs 1 and 2,
clean output.
Further, you can select the program background from Clean or Utility2,
and change the combination of signals from which it is configured. (PGM
Config)
– DSK mode: Treat P/P as four DSKs, with no background transitions. Of
backgrounds 1 to 4, set one to configure the program output. (PGM
Config) The signals which can be selected as the background are limited
to Out1 to 6 from M/E-1 to M/E-3.
Regardless of the current M/E Config mode, you can set the key preview
configuration to be video mode or key mode. In key mode, select whether
to link the key state to the on/off operation, or have it always on. (K-PVW
Config)
• User 1 to 8 Config: Assign the User regions, being color backgrounds 1 and
2, AUX1 to 48, monitor 1 to 8, frame memory 1 to 8, and color correctors 1
and 2, to any of User1 to User8.
• Logical M/E Assign: Make settings for handling PGM/PST hardware
logically as an M/E.
• DME Config: Set the DME channel assignments used on the individual
M/E and PGM/PST banks.
• Side Flags: Make settings relating to the side flag function (inserting a
selected image on both sides of a 4:3 image).
Input signal settings (Input)
• Input Phase Adjust: Carry out phase adjustment for each primary input.
• Through Mode: Set through mode for the input side. This applies only to
the primary inputs, and can be set independently for each primary input.