Filter
Top Products
394
Key Setting Operations Using Menus
Chapter 4 Keys
Note
This function is only supported on the MVS-8000G.
2
Press [Frame Delay], setting it to On.
Note
This function uses the resizer, and therefore the expected result of the
setting may not be obtained if conditions do not allow the resizer to be
used.
Carrying out a color mix for the key edge fill matte
When you select ‘Matte’ for the edge fill of a border, drop border, or shadow,
you can create a combination of color 1 and color 2 using a wipe pattern
generated by the dedicated pattern generator.
1
In the <Edge Fill> group of the Edge menu, select [Matte], then press
[Matte Adjust].
The edge fill Matte Adjust menu appears.
2
In the <Edge Matte> group, select [Mix Color], turning it on.
3
Adjust the following parameters.
a) The patterns are the same as standard wipes. (For details, see “Wipe Pattern List” in
Appendix (Volume 1) (page 560).)
To select the pattern, display the Mix Pattern Select menu by pressing
[Mix Pattern] in the edge fill Matte Adjust menu. After selecting one of the
patterns (standard wipe patterns 1 to 24) displayed in the Mix Pattern
Select menu, you can adjust the following parameters.
4
Adjust color 1 and color 2.
Knob Parameter Adjustment Setting values
1 Size Pattern size 0.00 to 100.00
2 Soft Softness of pattern edge 0.00 to 100.00
3 Pattern Pattern number
1 to 24
a)
Knob Parameter Adjustment Setting values
1 Size Pattern size 0.00 to 100.00
2 Soft Softness of pattern edge 0.00 to 100.00