Filter
Top Products
356
Executing a Transition
Chapter 3 Transitions
Notes
• A pattern limit only applies when a wipe or DME wipe is selected as the
transition type.
• A pattern limit cannot be applied to an independent key transition (see page
364).
Transition control block (standard type)
Setting the pattern limit with the fader lever
1
Move the fader lever to the position corresponding to a particular pattern
size.
• First make sure that the [PTN LIMIT] button is off.
• To check the pattern size on the preview monitor, first press the [TRANS
PVW] button, to select the transition preview mode (see page 363).
2
Press the [LIMIT SET] button.
This sets the current fader lever position as the pattern limit.
Setting the pattern limit by a menu operation
1
When a wipe is selected as the transition type, in the M/E or PGM/PST
menu, select first VF5 ‘Wipe,’ then HF4 ‘Edge/Direction.’
When a DME wipe is selected as the transition type, in the M/E or PGM/
PST menu, select first VF6 ‘DME Wipe,’ then HF4 ‘Edge/Direction.’
The Edge/Direction menu appears.
BKBD KEY1 KEY2 KEY3 KEY4
KEY
PRIOR
MIX
ALL
PST
COLOR
MIX
NAM
WIPE
SUPER
MIX
DME
PRIOR
SET
NORM
NORM
/REV
REV
TRANS
PVW
PTN
LIMIT
LIMIT
SET
KF
AUTO
TRANS
CUT
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
TRANS PVW button
PTN LIMIT button
LIMIT SET button