Filter
Top Products
29Signal Selection
Chapter 1 MVS-8000 Functions
a) Dual background bus mode (see below) can be selected.
Dual background bus mode
In this mode, the shifted signal on the background A row can be selected on the
key 1 row, and the shifted signal on the background B row can be selected on
the key 2 row.
To switch this mode on and off, it is necessary to assign this function to the
[PRE MCRO] button in the cross-point control block.
For details of the assignment operation, see “Overall Control Panel Settings
(Config Menu)” in Chapter 16 (Volume 2).
Note
For the following switcher banks, dual background bus mode is not available.
• When set to “Dual M/E Assign”
• When M/E Config is set to “DSK”
Signal Assignment and Selection
Assigning signals to buttons
Each of the 32 cross-point buttons and reentry buttons has a corresponding
button number, to which you assign a signal.
In addition to the signals input to the PRIMARY INPUTS 1 to 80 connectors
(1 to 34 connectors for the MVS-8000SF/8000ASF/8000GSF) on the rear
panel of the switcher, you can also select signals generated within the switcher.
Each button has assigned to it a video signal and a key signal, forming a pair.
You can set these video and key combinations in a Setup menu.
For details of Setup menu operations, see “Cross-Point Settings (Xpt Assign
Menu)” in Chapter 16 (Volume 2).