Filter
Top Products
46
Transitions
Chapter 1 MVS-8000 Functions
Flip-flop mode and bus fixed mode
For details of fader lever operation in bus fixed mode, see page 361.
Transition preview
With the preview output of the M/E banks and PGM/PST bank, you can check
the effect of a transition in advance. To carry out a transition preview, press the
[TRANS PVW] button in the transition control block. (See “Transition
Preview” (page 363).)
Note
In multi-program mode, DSK mode (page 199) or bus fixed mode (page 45),
it is not possible to carry out a transition preview.
Pattern limit
When a wipe or DME wipe pattern is selected for the transition, you can
specify the range of movement of the wipe pattern through the course of the
transition, for each bank independently.
When the pattern limit function is enabled, carrying out a transition results in
the following effect for example settings.
• When the limit value is set to 50%, the effect at the end of the transition is
the same as when the fader lever is at the center position in the normal case
(with the pattern limit function disabled); the wipe pattern does not complete.
• When the limit value is set to 0%, the wipe effect is completely disabled, and
carrying out the transition produces no change in the image.
A
B
BLACK
BLACK
A
B
BLACK
BLACK
A
B
BLACK
BLACK
Buttons lit
Fader
lever
Flip-flop mode
Bus fixed mode