Filter
Top Products
514
Frame Memory Clip Operations
Chapter 7 Frame Memory
6
Press the thumbnail of the clip you want to recall.
7
Press [Recall].
This recalls the clip file, which is assigned to the FM you selected in step 2.
In pair mode, if a clip is selected, the main file is output to FM1, and the
sub file to FM2. In single mode, when only one of FM1 and FM2 is
selected, the front file on the thumbnail is output.
To recall in direct recall mode
Direct recall means that pressing a thumbnail immediately recalls the file.
In this mode, only the front thumbnail file is recalled.
1
In step 7 above, instead of pressing [Recall], press [Direct Recall].
2
Press the thumbnail for the file you want to recall.
This immediately recalls the file.
To display the subsidiary file in front
With the direct recall mode on, press [Sub Display], turning it on.
Clip Playback
You can play a recalled clip by a menu operation or by using the device control
block.
Note
With a pair file recalled, it is possible to set [Pair] to Off and carry out a single
file operation, but if you then set [Pair] to On again, the output of frame
memory may be black. In such cases it is necessary to recall the pair file once
more.
Playing a clip using the menu
1
In the Frame Memory menu, select VF2 ‘Clip’ and HF2 ‘Play.’
The Play menu appears. The status of the clip shown in the current target
FM selection buttons appears here.