Filter
Top Products
188
Setup
Chapter 1 MVS-8000 Functions
Operation mode setting
• Single Proc mode: The control panel controls a single switcher and up to
two DMEs.
• Single Simul mode: See “Special system setting (Single Processor Simul
mode)” (page 188).
• Dual Simul mode: The control panel controls two switchers and DMEs
simultaneously.
Device hierarchical relationship setting
• Panel Assign: Specify the switcher controlled by a control panel.
• Switcher Assign: Specify the DME connected to a switcher.
Special system setting (Single Processor Simul mode)
When using a combination of a 4M/E switcher processor and a 4-channel DME
processor in an HD system, the Single Processor Simul mode is available. In
this mode, M/E-1 on the switcher processor is linked to M/E-3, and M/E-2 is
linked to P/P. As a result, the M/E-1 and M/E-2 panel buttons go off, and
cannot be operated.
In this mode, the screen aspect ratio is fixed, as follows.
Relation between switcher and DME: Operations are linked with the screen
aspect ratios the same.
Notes
• The waveforms for wipe pattern numbers 23, 24, 26, and 27 are the same
in 4:3 and 16:9 modes.
• Color backgrounds, frame memory, and other functions used on the
whole switcher operate at 16:9.
Note on creating a user programmable DME: The keyframe registers used
for creating a user programmable DME are divided by screen aspect ratio
as shown in the following table.
Processor Bank or channel Screen aspect ratio
Switcher processor M/E-3 and P/P 16:9
M/E-1 and M/E-2 4:3
DME processor Channels 1 and 2 16:9
Channels 3 and 4 4:3
Register
numbers
Screen aspect
ratio
Switcher bank Channel
101 to 149,
201 to 249,
301 to 349
16:9 M/E-3 P/P Ch1 Ch2