Filter
Top Products
204
Setup
Chapter 1 MVS-8000 Functions
Copy (Tally Copy)
Copy the tally information pertaining to a particular source to a different
source.
These settings are common to the parallel tally and serial tally.
Parallel port settings (Parallel Tally)
Make the parallel port settings for output of tally information pertaining to
sources and destinations.
For each of the tally output terminal numbers, specify the tally type, and source
address or destination level and address.
Serial tally settings (Serial Tally)
Make the serial tally settings, including tally type and source address for each
serial tally port.
Simple Connection to MKS-8080/8082 AUX Bus Remote
Panel (Option)
To connect the MKS-8080/8082 AUX Bus Remote Panel to a CCP-8000
Center Control Panel using an S-Bus data link requires a BKPF-R70A Routing
Switcher Controller Board or similar primary station and various settings for
connection.
However, using a simple connection, the need for an S-Bus data link primary
station is avoided, and direct connection to the MKS-8080/8082 is possible.
A simple connection is possible if the following conditions are met:
• There are no devices other than the CCP-8000 and MKS-8080/8082
connected on the S-Bus data link.
• There are no more than 16 MKS-8080/8082 units connected on the S-Bus
data link.
For details of the connection procedure, see “Procedure for Simple
Connection” in Chapter 16 (Volume 2).