Filter
Top Products
275Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
ring moves, shrinks, or magnifies a key
to which the resizer function is applied
to. When this button is held down, the
trackball or Z-ring operation is
switched to a finer control. (fine mode)
ROT (RSZE: resizer): Press this button,
turning it on, to enable the resizer.
CLR WORK BUFR (CLR WORK
BUFR): Pressing this button once
returns the two-dimensional
transformation settings to the defaults.
Pressing twice in rapid succession
returns all resizer parameter values to
the defaults.
X, Y: These restrict the axes affected by the
trackball and Z-ring to the x- or y-axis.
Z: This restricts the axes affected by the
trackball and Z-ring to the z-axis.
CTR (center): Pressing this button once
changes the two-dimensional
transformation settings to the closest
detent values. Pressing twice in rapid
succession returns the two-dimensional
transformation settings to the defaults.
c Trackball
When the positioner operation mode is
enabled
By moving this, you can move the pattern
in the x-axis and y-axis directions.
When the three-dimensional transform
operation mode is enabled
Move the trackball to control the x- and y-
axes in a three-dimensional transform.
When the [SRC] or [TRGT] button is held
down, the trackball operation is switched to
a finer control. (fine mode)
When the resizer control mode is
enabled (for the MVS-8000G only)
By turning the trackball, you can move in
the x- and y-directions of the key to which
the resizer is applied, and change the aspect
ratio.
When the [LOC SIZE] or [LOC XYZ]
button is held down, the trackball operation
is switched to a finer control. (fine mode)
d Z-ring
When the positioner operation mode is
enabled
When the [USER] button is selected, by
turning the ring you can adjust the size of
the pattern.
When the three-dimensional transform
operation mode is enabled
Turn this ring to control the z-axis in a
three-dimensional transform.
When the [SRC] or [TRGT] button is held
down, the Z-ring operation is switched to a
finer control. (fine mode)
When the effect run control mode is
enabled
By turning the Z-ring, you can run the
keyframe effect, independent of the STOP
NEXT KF, EFF LOOP, and similar settings
in the keyframe control block. Turn
clockwise to run the effect in the normal
direction, and counterclockwise for the
reverse direction.
When the resizer control mode is enabled
(for the MVS-8000G only)
By turning the ring, you can zoom the key
to which the resizer is applied, and change
the aspect ratio.
When the [LOC SIZE] or [LOC XYZ]
button is held down, the Z-ring operation is
switched to a finer control. (fine mode)
When the VTR/disk recorder/frame
memory operation mode is enabled
Turning the Z-ring controls the tape
transport/disk drive/frame memory clip
operations, at a speed determined by the
operating buttons. Turn clockwise for the
normal direction, and counterclockwise for
the reverse direction.