Filter
Top Products
57Keys
Chapter 1 MVS-8000 Functions
Full mode: All settings except transition (the same parameters as simple mode,
Fine Key, key modifiers, main and sub mask settings, chroma key detailed
settings, and so on)
For the settings for these modes, see “Settings Relating to Keys, Wipes and
Frame Memory (Key/Wipe/FM Menu)” in Chapter 16 (Volume 2).
Key Snapshots
Key settings other than the key on/off status and the key priority can all be
instantaneously saved in a dedicated register, for recall when required. A key
snapshot comprises three values: a cross-point button number, key memory full
mode, and independent key transition, and can be called in any combination.
There are four key snapshot registers for each keyer.
For details of key snapshot operations, see “Key Snapshots” (page 433).
Blink
The blink function provides the following effects.
Key blink: The key is inserted and deleted at the specified frequency.
You can also set the frequency and the proportion of the cycle for which
the key is inserted.
Edge blink: Key fill and key edge fill are interchanged at the specified
frequency. You can specify both the frequency and the proportion of the
cycle for which the interchange occurs.
The blink settings are in the Transition menu for each key. (See “Blink
Function” (page 404).)
Key Default
With a simple operation you can return the key adjustment values to their
defaults.
The adjustment values which can be returned to their default values are as
follows.
• Adjustment values for the particular key type (Clip, Gain, Density, Filter,
etc.)
In the case of chroma keying, all adjustment values return to their default
values.
• Key position
• Key inversion