Filter
Top Products
92
Frame Memory
Chapter 1 MVS-8000 Functions
control block, see “Overall Control Panel Settings (Config Menu)” in
Chapter 16 (Volume 2).)
In the Frame Memory menu, effect creation follows the image file names. Of
the eight characters in the file names, if files have the same characters except
for the last three characters they are treated as an image file group, and the
effect is created with the last three (numeric) characters in sequence.
Note
When creating the effect in pair mode (see page 87), the files used must be
main files and sub files with the same last three (numeric) characters in the file
name.
Frame Memory Clip Function
The frame memory clip function is not supported on the MVS-8000.
What is a “frame memory clip”?
Movies can be read into frame memory, and recalled and played back. A movie
held in frame memory is called a “frame memory clip.”
A frame memory clip can be named using up to four characters. (For details of
frame memory clip names, see “Continuously capturing still images (record)”
(page 91).)
Ancillary data
In a frame memory clip, in addition to the video image, you can also record and
play back ancillary data which can be used as embedded audio (MVS-8000A
and MVS-8000G only).
To record the ancillary data, in the Setup menu the frame memory saving mode
must be set to “save with ancillary data” (see “Saving a frame memory clip
including ancillary data” in Chapter 16 (Volume 2)).
Notes
• With this setting, the saving mode for still images also changes to “save with
ancillary data,” but when playing back a still image the ancillary data is never
played.
• When you change the saving mode, the frame memory is initialized, and any
existing recorded frame memory data is lost.
When the frame memory saving mode is set to “save with ancillary data,” the
following ancillary data status information is added to a frame memory clip.