Filter
Top Products
434
Key Snapshots
Chapter 4 Keys
The system switches to key snapshot mode, and the key source name
display/key snapshot buttons show the status of registers 1 to 4 for key 1.
Off: Nothing is saved in the register.
Lit orange: Settings are saved in the register.
For a register holding a snapshot, the register name is shown as up to eight
characters.
3
Hold down the [K-SS STORE] button, and press the key source name
display/key snapshot button corresponding to the register in which you
want to save the snapshot.
The key source name display/key snapshot button which you pressed lights
yellow.
Note
If you save a key snapshot in a register for which the button is lit orange or
yellow, the existing contents of the register are overwritten.
Recalling a key snapshot
For example, the following procedure recalls the state of the M/E-1 key 1
settings.
1
In the M/E-1 independent key transition control block, press the key
delegation button [KEY1], turning it on.
2
Press the [K-SS] button, turning it on.
3
Set the following buttons on or off, depending on the information you want
to recall.
(These buttons are not provided in the downstream key control block.)
[K-MOD ENBL] button: When this is on, the key settings and key
modifiers are recalled. When this is off, they are not recalled.
[K-TR ENBL] button: When this is on, the independent key transition
settings are recalled. When this is off, they are not recalled.
If both buttons are off, the key memory function is enabled and only the
saved selection of key fill and key source signals is recalled.
4
Press the key source name display/key snapshot button corresponding to
the register you want to recall.
The button you pressed lights yellow, and this recalls the key snapshot.
To cancel a recall carried out in the downstream key control block, press
the [UNDO] button in the downstream key control block.