Filter
Top Products
390
Key Setting Operations Using Menus
Chapter 4 Keys
Key Edge Modifications
To modify the key edge of key 1 on the M/E-1 bank, use the following
procedure.
1
In the M/E-1 >Key1 menu, select HF2 ‘Edge.’
The Edge menu appears.
2
Select the edge type in the <Edge> group.
For an overview of the key edge modifications, see “Edge modifiers”
(page 52).
Normal: unadorned edge
Border: edge with border applied
Drop Border: edge with drop border applied
Shadow: edge with shadow applied
Outline: edge used as outline
Emboss: embossing effect applied to edge
If you select [Normal], skip to step 7.
3
Set the border width and other parameters.
When border or outline is selected: The setting parameters depend on
the key type and whether the separate edge function is enabled or not.
To enable the separate edge function, press [Separate Edge], setting it
on.
• Separate edge off
a) In the “4H mode” and when [Fine Key] (page 393) is on, the setting value range is 0.00
to 4.00.
b) When a wipe pattern key or key wipe pattern key is selected as the key type
• Separate edge on
The left, right, top, and bottom border or outline widths can be adjusted
Knob Parameter Adjustment Setting values
1WidthWidth
0.00 to 8.00
a)
(0.00 to 100.00)
b)
3 Density Density 0.00 to 100.00