Filter
Top Products
388
Key Setting Operations Using Menus
Chapter 4 Keys
(See “Cross-Point Settings (Xpt Assign Menu)” in Chapter 16
(Volume 2).)
Split: You can select a key source signal independently of the key source
automatically selected in Auto Select mode.
6
When [Split] was selected in step 5, hold down the [SPLIT] button in the
key control block, then in the cross-point control block key 1 row, select
the key source signal. Alternatively, hold down the key delegation button
in the transition control block and press a cross-point button in the key 1
row to select the key source signal.
Notes
• In the above-stated key 1 row operation, you can only select a key signal
assigned to a cross-point button. For the method of selecting a video
signal, see “To select a video signal assigned to a cross-point button”
below.
On the MVS-8000, the video signal selection operation is not supported.
• When [Split] is selected, the key memory function (see page 56) is
disabled.
To select a video signal assigned to a cross-point button
By selecting the key source bus with an auxiliary bus control block AUX
delegation button, and pressing the cross-point button, it is possible to select
the video signal assigned to the cross-point button.
(If you press the cross-point button with holding down [KEY], the key signal
assigned to the cross-point button.)
Note
In the above operation, the following settings must have been made.
• Assigning the key source bus to an AUX delegation button
For details, see “Auxiliary Bus Control Block Settings (Aux Assign Menu)”
in Chapter 16 (Volume 2).
• Setting the [KEY] button operating mode
For details, see “Operation Settings (Operation Menu)” in Chapter 16
(Volume 2).
This operation is not supported on the MVS-8000.
Carrying out a color mix for key fill
When [Matte] is selected for key fill, you can combine color 1 and color 2. For
the combination, you can use not only a key wipe generator pattern, but also
the dedicated pattern for key edge color mix.