Filter
Top Products
498
Still Image Operations
Chapter 7 Frame Memory
Saving a freeze image
To save a captured still image in a file, use the following procedure in the Still
>Freeze/Store menu.
1
Press [Store].
The keyboard window (see page 331) appears.
2
In the keyboard window, enter the file name (maximum 8 characters).
Note
The following names cannot be used:
CON, PRN, AUX, CLOCK$, NUL, COM0, COM1, COM2,
COM3, COM4, COM5, COM6, COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7, LPT8,
LPT9
3
In the keyboard window, press the [Enter] button.
This saves the still image file in memory.
The destination folder is the folder selected in step 4 of “Freezing an image
and writing it to memory.”
If the entered folder name already exists, a message to confirm overwriting
appears.
When the system is powered off, the file saved in memory is erased.
However, you can recall a backed up file in the Frame Memory menu.
For details, see “File Backups” (page 531), and “Restoring backed up
files” (page 531).
Carrying out a freeze and store simultaneously
Press [Freeze & Store], turning it on.
The system enters the freeze and store mode.
In this state, if you press [Frame] or [Field], this carries out a freeze, and
simultaneously stores in a still image file.
Setting video processing
To set video processing for the signal selected on a frame memory source bus,
use the following procedure in the Still >Freeze/Store menu.
1
In the <Video Process> group, press [Video Process], turning it on.
2
Use the knobs to adjust the following parameters.