Filter
Top Products
219Macros
Chapter 1 MVS-8000 Functions
Post-macro: Mode in which the macro is executed after carrying out the button
function
Macro only: Mode in which the button function is not executed, and the macro
only is executed
The selection of pre- or post-macro mode is carried out in the cross-point
control block of the PGM/PST bank or the M/E banks. For the macro-only
mode, assign the selection function to a utility/shotbox control block button or
user preference button, and make the selection by pressing the button.
Alternatively, without pressing the button, you can make the selection simply,
by simultaneously pressing the pre-macro and post-macro selection buttons in
the cross-point control block.
You can assign any one of the 99 macro registers to a button.
For a button whose function is switched by delegation, you can make a separate
macro attachment for each function.
For each control panel, you can make up to 1000 macro attachment settings.
The macro attachment setting is possible for the following bus buttons. For
button locations, see pages in parentheses.
Block Button
PGM/PST or M/E bank • Background A row cross-point buttons
(page 256)
• Background B row cross-point buttons
(page 256)
• Key 1 bus cross-point buttons
(page 256)
• Key 2 bus cross-point buttons
(page 256)
• Key 3 bus cross-point buttons
(page 256)
• Key 4 bus cross-point buttons
(page 256)
• Utility 1 bus cross-point buttons
(page 256)
• Utility 2 bus cross-point buttons
(page 256)
• DME external video bus cross-point buttons
(page
256)
• DME utility 1 bus cross-point buttons
(page 256)
• DME utility 2 bus cross-point buttons
(page 256)
• [AUTO TRANS] button
a)
(page 260)
• [CUT] button
(page 260)
• [KEY1 ON] to [KEY4 ON] buttons
a)
(pages
260
,
304)
• The button to which the same function as that of
VTR/disk recorder/Extended VTR/frame memory
clips play, cue, and stop buttons
(page 260)
• Memory recall buttons
i)
• Buttons set to “Inhibit”
(page 256)
Auxiliary bus control block
• Cross-point button1st row
b)
(page 288)
• Cross-point button 2nd row
b)
(page 288)
Keyframe control block • [RUN], [REWIND] and [FF] buttons
(page 281)
• [NORM], [REV], and [NORM/REV] buttons
(page
281)