Filter
Top Products
366
Independent Key Transitions
Chapter 3 Transitions
Setting the Independent Key Transition Rate
There are two ways of setting the transition rate: using the Flexi Pad control
block or numeric keypad control block to enter a numeric value, or using the
Key menu to access the Transition menu for the M/E or PGM/PST bank.
You can also display the transition rate, independent key transition rate, and
fade-to-black transition rate for each of the M/E and PGM/PST banks, and
change the settings. (See “Displaying a List of Transition Rates and Changing
the Settings” (page 553).)
When the setup selection is for separate transition rates for inserting or deleting
a key, you can set both rates independently. For example, with the system in
the state with the key not inserted, the transition rate setting applies to key
insertion.
Setting the independent key transition rate in the Flexi Pad
control block
Note
In the PGM/PST bank or when using a simple-type transition control block,
you cannot use the Flexi Pad control block to set the transition rate.
1
In the Flexi Pad control block of the M/E bank, hold down the [TRANS
RATE] button, and in the independent key transition control block, press
the delegation button [KEY1] to [KEY4] for the key for which you want
to set the transition rate.
The memory recall section display is now ready to accept the entered
independent key transition rate.
2
Enter the desired transition rate with the numeric keypad.
• Enter a value of up to three digits.
• To cancel the entry, press any of the six buttons in the leftmost column
([WIPE], [DME], ...) or the [TRANS RATE] button.
For details of frame input mode and timecode input mode, see page 352.
3
Press the [ENTR] button.