Filter
Top Products
466
Basic Procedure for DME Wipe Settings
Chapter 6 DME Wipes
Basic Procedure for DME Wipe Settings
You carry out DME wipe setting operations principally using the DME Wipe
menu for each of the M/E-1 to M/E-3 and PGM/PST banks.
This section describes the basic procedures for DME wipe settings, taking the
M/E-1 >DME Wipe menu as an example.
For details of independent key transition DME wipe settings, see “DME Wipe
Settings for Independent Key Transitions” (page 477).
For details of resizer DME wipe (for MVS-8000G only), see page 481.
Note
For one M/E bank, DME effects (including external processed keys) can be
used in up to two places on the DME dedicated interface and in only one place
on the SDI interface simultaneously.
When combining the SDI interface with the dedicated interface, you can apply
DME effects to a maximum of three keys. (Requires a setting in setup.)
DME Wipe Settings Menu
Accessing the DME Wipe menu
To access the M/E-1 >DME Wipe menu, use any of the following operations.
• In the menu control block, select the top menu selection button [M/E 1], and
press VF6 ‘DME Wipe.’
• In the transition control block of the M/E-1 bank, press the transition type
selection button [DME] twice in rapid succession.
• In the Flexi Pad control block of the M/E-1 bank, press the [DME] button
twice in rapid succession.
Any of the above operations displays the M/E-1 >DME Wipe menu.
DME Wipe Pattern Selection
You can select a DME wipe pattern in the DME Wipe menu, or by entering a
pattern number from the Flexi Pad control block.