Filter
Top Products
445Basic Procedure for Wipe Settings
Chapter 5 Wipes
2
Press [Split], turning it on.
3
Set the following parameters.
Modifying the wipe pattern edge
1
In the M/E-1 >Wipe menu, select HF4 ‘Edge/Direction.’
The Edge/Direction menu appears.
2
In the <Edge> group, select the edge type.
Border: border
Soft: soft edge
Soft Border: soft border
For an overview of the edge types, see “Edge” (page 65).
3
Set the parameters according to the selection in step 2.
• When border is selected
• When soft edge is selected
• When soft border is selected
4
When you selected border or soft border, select the edge fill signal in the
<Edge Fill> group.
Utility 2 Bus: signal selected on the utility 2 bus
Matte: signal from the dedicated color matte generator
Knob Parameter Adjustment Setting values
1 Split No Number of splits 1 to 4 (integer)
2 Spacing Spacing between adjacent
patterns
0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Width Border width 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Soft Edge softness 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Width Border width 0.00 to 100.00
2 Inner Soft Border inner softness 0.00 to 100.00
3 Outer Soft Border outer softness 0.00 to 100.00