Filter
Top Products
474
Basic Procedure for DME Wipe Settings
Chapter 6 DME Wipes
Adjusting the DME wipe pattern cropping
Note
When pattern numbers 1701 and 1702 are selected, crop cannot be used.
1
In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’
The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time. Some patterns need no selection which is fixed in the
<Ch Select> group.
3
In the <Crop Mode> group, press [Crop], turning it on.
4
Set the following parameters.
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
In 16:9 mode, to crop to 4:3 aspect ratio
In the <Crop Mode> group, press [4:3], turning it on.
To set the action when a DME wipe crop transition is executed
1
In the M/E-1 >DME Wipe menu, select HF5 ‘Modify.’
The Modify menu appears.
2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
Knob Parameter Adjustment Setting values
1 Top Crop the top of the image –100.00 to +100.00
2 Left Crop the left of the image –100.00 to +100.00
3 Right Crop the right of the image –100.00 to +100.00
4 Bottom Crop the bottom of the image –100.00 to +100.00