Filter
Top Products
270
Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
j ON AIR indicators
These light red when the corresponding
DME channels are included in the final
program output.
k Output destination specification
buttons
MON (DME monitor): Hold down this
button and press the selection button
for the DME channel you want to
assign to the monitor output; you can
then monitor the output signal on the
DME monitor output.
While this button is held down, the
DME channel selection buttons light as
follows, allowing you to check the
monitor assignment.
Lit amber: DME channel that can
currently be monitored
Lit green: DME channel currently
assigned to the monitor output
FM FEED (frame memory feed): When
you press this button, it lights
momentarily amber, then for the
currently selected keyer, the key
processed signals are selected for frame
memory sources 1 and 2. If a DME is
selected on the currently selected
keyer, the key fill and key source
signals to which a DME effect is
applied are assigned to frame memory
sources 1 and 2; otherwise the key fill
and key source are assigned.
Carrying out a frame memory feed
causes the [PROC KEY] button to light
amber.
PROC KEY (processed key): When this
button is on, the key fill/source signal
subjected to key processing or signal
subjected to a DME effect on the
currently selected keyer can be selected
as a reentry signal (PROC V or PROC
K) for the M/E or PGM/PST bank, on
the auxiliary bus or the like.
l OVERRIDE button
To select a DME channel already allocated
to another keyer or transition to the
currently selected keyer (or transition), hold
down this button, and press the DME
channel selection button.
m TRACE button
When a DME channel is already allocated
to another keyer or transition, hold down
this button, and press the corresponding
DME channel selection button, to switch to
the state in which the keyer (or transition) to
which the DME channel is allocated is
currently selected.
n AUTO DELEG (auto delegation)
button
When this button is on, the key delegation
selection state of the key control block is
linked to the key delegation selection state
of the independent key transition control
block.
o RESIZER button
Enables or disables resizer on the MVS-
8000G.
For details on resizer, see page 419.