Filter
Top Products
358
Executing a Transition
Chapter 3 Transitions
• When you move the fader lever, the transition is carried out from the
pattern limit state to the state before the pattern limit transition was
carried out.
Moving the fader lever even a little synchronizes the fader lever position
with the transition state, and you can move the fader lever either in the
forward direction or in the reverse direction.
Depending on the Setup settings, the transition may be executed at the
instant you press the [PTN LIMIT] button, and the button goes off. In this
case, execution continues for the time specified by the dedicated transition
rate in the menu setting, as far as the state of the next transition.
For details of the setting, see “Settings Relating to Keys, Wipes and Frame
Memory (Key/Wipe/FM Menu)” in Chapter 16 (Volume 2).
To set the transition rate when the pattern limit is released
1
In the <Pattern Limit Release> group of the Edge/Direction menu, select
one of the following.
Auto Trans Rate: Use the transition rate set in the transition rate control
block
Independ Trans Rate: Independent transition rate
2
If you selected “Independ Trans Rate” in step 1, adjust the following
parameter.
Knob Parameter Adjustment Setting values
1 Transition Rate Independent transition rate 0 to 999 (frames)