Filter
Top Products
278
Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
Move to the right to run the effect in the
normal direction, and to the left for the
reverse direction.
When the VTR/disk recorder/frame
memory operation mode is enabled
Moving the joystick sideways controls the
tape transport/disk drive/frame memory
clip operation, at a speed determined by the
operating buttons.
When the resizer control mode is
enabled (for the MVS-8000G only)
Move for operations in the x-, y-, and z-
axes. Hold down the button on the tip of the
joystick to switch the joystick operation to
a finer control. (fine mode).
Move to the right for the normal direction,
and to the left for the reverse direction.
Device Control Block (Search Dial)
The description below of frame memory
clip operations applies only to the MVS-
8000A/8000G.
Using the device control block (search
dial), you can directly operate an XDCAM,
disk recorder, VTR, other external device,
frame memory clip, or shot box. The device
control block (trackball) and device control
block (joystick) can be used together.
TIME
LINE
DEV
1
CURRENT
START TC
STOP TC
DEV
2
DEV
3
DEV
4
DEV
5
DEV
6
FM1
CLIP
FM2
CLIP
SBOX
1
SBOX
2
SBOX
3
START
TC
STOP
TC
SET
START
TC
SET
STOP
TC
SET
DUR
STB
OFF
ALL
STOP
STOP
REC
PLAY FFREWCUE
DELAY
SHTL JOG VAR ENBL
1 Timecode display
2 Device selection buttons
4 DELAY button
5 Editing
buttons
6 External device
operation buttons
7 TIMELINE button
8 STOP button
9 Search dial
3 SBOX buttons