Filter
Top Products
274
Names and Functions of Parts of the Control Panel
Chapter 2 Menus and Control Panel
LOCAL (DELAY): Press this button,
turning it on, to enter a delay value
from the numeric keypad control block.
GLB (STB OFF: standby off): Press this
button to switch to standby off mode.
This button cannot be used for frame
memory clip operations.
SRC (REC: record): Press this button at
the same time as the [Y] button to start
recording. This button cannot be used
for frame memory clip operations.
TRGT (STOP): Press this button to stop
the tape, disk or frame memory clip.
AXIS LOC (START TC: start
timecode): Press this button to set the
timecode of the start point at that time.
The timecode of the start point is
updated to the current time each time
this button is pressed.
When the device the operation applies
to is a VTR/disk recorder, the start
point updated by the setting of the
[MENU] button is as follows.
When the [MENU] button is On:
start point of the timeline
When the [MENU] button is Off:
start point of Cueup & Play
ASP PERS (STOP TC: stop timecode):
Press this button to set the timecode of
the stop point at that time. The
timecode of the stop point is updated to
the current time each time this button is
pressed.
When the device the operation applies
to is a VTR/disk recorder, the stop
point updated by the setting of the
[MENU] button is as follows.
When the [MENU] button is On: stop
point of the timeline
When the [MENU] button is Off:
stop point of Cueup & Play
LOC SIZE (VAR: variable speed
playback): Pressing this button and
turning the Z-ring plays back the tape,
disk or frame memory clip at a variable
speed and direction proportional to the
rotation angle of the Z-ring. The
variable speed range is –1 to +3 times
normal playback speed.
LOC XYZ (SHTL: shuttle): Pressing this
button and turning the Z-ring plays
back the tape, disk or frame memory
clip at a speed and direction
proportional to the rotation angle of the
Z-ring.
ROT (JOG): Pressing this button and
turning the Z-ring plays back the tape,
disk or frame memory clip at a speed
and direction proportional to the
rotation of the Z-ring.
CLR WORK BUFR (CUE): Pressing this
button cues the tape, disk or frame
memory clip automatically to the start
point.
X (REW: rewind): Press this button to
rewind the tape, disk or frame memory
clip.
Y (PLAY): Press this button to play the
tape, disk or frame memory clip.
Z (FF): Press this button to fast forward the
tape, disk or frame memory clip.
CTR (ALL STOP): Press this button to
stop all tape transport/disk drive/frame
memory operations.
When the resizer control mode is enabled
(for the MVS-8000G only)
LOCAL (K1): Select key 1.
GLB (K2): Select key 2.
SRC (K3): Select key 3.
TRGT (K4): Select key 4.
LOC SIZE (ASP: aspect): Pressing this
button and operating the trackball or Z-
ring changes the aspect ratio of a key to
which the resizer function is applied to.
When this button is held down, the
trackball or Z-ring operation is
switched to a finer control. (fine mode)
LOC XYZ (LOC: location): Pressing this
button and operating the trackball or Z-