Filter
Top Products
15 Tools
4
Enter a speed dial number of broadcast destination (001 to 099) or group number (#01 to
#09) registered on the relay station with the numeric keypad, and then select [Add].
Note • If there are more than one broadcast destinations, repeat step 4.
5
To print a document also at the relay station, under select [On] for [Print at Relay Station].
6
Select [Save].
Billing - Day Time, Billing - Night Time, Billing - Midnight
Set the connection time for one unit charge in each of the time bands (daytime/night/
midnight).
You can set a value from 0.1 to 255.9 seconds in 0.1 second increments.
This item is displayed when [Accounting] > [Accounting Type] is set to [Local Accounting] and
[Fax] is set to [Enable Accounting] under [Auditron Mode]. For information on how to enable the
feature, refer to "Auditron Mode" (P.403).
The information registered can be confirmed by printing a Billing Data List. For information about
how to print, refer to "Billing Data List" (P.265).
1
Select one of [Billing - Day Time], [Billing - Night Time], and [Billing - Midnight].
2
Select [Billing].
3
Enter the time for one unit charge from 0.1 to
255.9 seconds in 0.1 second increments with the
numeric keypad.
4
Select [Save].
When the [Delete Entry] Button is Selected
Selecting this button deletes all the information registered for the address selected. To delete
all information registered, select [Delete].
Note • Deleted information cannot be restored.
Create Fax Group Recipients
You can register addresses for broadcast transmission as a group. Each group can include up
to 20 address numbers. The maximum number of groups that can be registered is 50.
Note that recipients to be added to a group must be registered in the speed dials on the
Address Book.
Note • Even when the speed dial number of fax recipients (address book entries) are included in a group, the
machine does not send faxes to the recipients if their address types are set to [Email] or [Server].
• You cannot include a group in another group.
• You can use wildcards for specifying the numbers in the last one or two digits as shown in the
following example:
- 001*:Specifies the 10 addresses with address numbers 0010 to 0019.
- ****:Specifies all address numbers.
396